.png/:/rs=h:277,cg:true,m/qt=q:95)
Ozonatrim Inside and Outside Corner Installation
Tools & Materials Needed:
- Tape measure
- Nail Gun with 16 gauge finishing nails
- Pencil for marking
- Manual saw (acceptable) or power miter saw (recommended for precision)
- Safety goggles and gloves
- Utility knife/sandpaper (optional, for smoothing edges
Ozonatrim Inside and Outside Corner Installation
Step 1: Measure
Step 3: Test Fit
Step 1: Measure
Measure the height between the chair rail and the baseboard at the installation location. For best results, measure slightly on the plus side to ensure a snug fit.
Step 2: Cut
Step 3: Test Fit
Step 1: Measure
Using a manual or power miter saw, cut the Ozonatrim molding to the measured length. Ensure the angle matches the required corner configuration for a seamless fit.
Step 3: Test Fit
Step 3: Test Fit
Step 4: Secure the Molding
Before securing the molding, test fit the cut piece in place. Adjust as necessary to achieve a professional, gap-free fit.
Step 4: Secure the Molding
Step 4: Secure the Molding
Step 4: Secure the Molding
Using a nail gun and 16-gauge finish nails, secure the molding by nailing at the top, middle, and bottom. Ensure each nail is flush with the surface to avoid gaps or misalignment.
Step 5: Finish
Step 4: Secure the Molding
Step 5: Finish
Fill nail holes with light spackle or silicone for a smooth finish. If needed, lightly sand the filled areas once dry. Optionally, apply paint or touch-up finish to blend the molding seamlessly with the surrounding décor.
By following these steps, you can achieve a professional and polished installation of Ozonatrim inside and outside corner molding.
